1035589A-3/9
2X
2X
Install Landing Pads.
Continue with
Control Tower
installation.
•
Using the hex wrench install each
Catch Mount
and pad as pictured (Catch Mounts are located diagonally from one another). Fully tighten.
•
Using the hex wrench install the fastener, washer,
Bare Mount
, and pad as pictured (bare Mounts are located diagonally from one another).
To prevent screws from cross-threading start threading fastener using your fingers. Fully tighten.
•
Use covers whenever Control Towers are not installed.
•
store covers in safe place whenever Control Towers are installed.
•
Periodically remove landing pad and clean under pad.
•
Periodically inspect pad for wear or cracking. replace if damaged.
ATTACHMENT
HARDWARE CAN
LOOSEN OVER TIME.
CHECK AND TIGHTEN
AS NECESSARY,
BEFORE EACH USE.
RECOMMEND
INSTALLATION
TORqUE: 20 IN-LBS
(2.3Nm)
RECOMMEND
INSTALLATION
TORqUE: 20 IN-LBS
(2.3Nm)
CATCH MOUNT
BARE MOUNT
FAsTeNer (M6)
FAsTeNer (M8)
