Bushing pr
e installed to
sho
w cor
rect orienta
tion.
1033438N-2/
18
Install bolt, and washer.
For 1-1/4" hItches: remove the 2" hItch adapter, and sleeve.
Remove the hex
bolt from the
adapter using hex
wrench.
For 2" hItches: proceed to next step.
Remove the adapter
from the tongue.
Remove the sleeve
from the tongue.
• IMPORTANT: Pivot plate must fit over
step on axle.
• Install locking bolt, passing through
large washer.
IMPORTANT: You should
not be able to pivot
mast without the tongue
mounted in hitch receiver.
Install tongUe to mast
Put pivot
plate in
place.
Bolt cannot be adjusted after adhesive
patch sets. Patch sets quickly!
FULLY TIGHTEN with adjustable
wrench until very snug.
If the bushing slides
out during installation,
replace as shown with
the lip side up.
•
Insert mast
through tongue.
•
Lay mast
assembly
down flat
on a clean
non abrasive
surface.
Read and remove
"Important Warning" tag.
