1033015D-3/12
TEST THE
INSTALLATION:
Push up on bar end to
test installation. Grab
the bar near the towers
and pull back and forth.
IF THE TOWER SLIDES OR CROSSBAR CAN ROTATE, CHECK TOWER FOR
TIGHTNESS AND RETIGHTEN SCREWS.
SKS
®
Lock Cores are optional.
Refer to Lock Core instructions for
installation.
CROSSBAR SPREAD:
The distance between the Yakima
crossbars is determined by the
accessories you wish to carry.
The Crossbar Spread Table will tell
you how much crossbar spread your
accessories require.
(Refer to your YAKIMA Dealer,
or go online at www.yakima.com)
LOAD LOCATION:
FOR EASE OF LOADING, CONSIDER
WHERE THE MOST CONVENIENT
PLACEMENT OF YOUR LOAD
WOULD BE BEFORE COMPLETING
THE INSTALLATION.
If you have not been instructed to fully tighten Landing
Pads, do so now. Tighten hex screws through the slots
in the Control Towers.
Push down and fully tighten Towers.
Firmly close covers until both
sides snap.
Installation Tips:
• Measure equal distances
from front towers.
USE CAUTION WHEN
OPENING YOUR HATCH.
On some vehicles, hatch
interference with accessories
is unavoidable.
“SNAP”
