Gesture and Motion Evaluation Kits (Digital) USEQMSK_____00
The above information is believed to be correct but does not purport to be all inclusive and must be used only as a guide.
© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard
Fort Lauderdale, FL
33301 USA • 954-766-2800 • www.kemet.com
4
3
INSTALLATION
3.1 Installing the KEMET Gesture & Motion Sensing Evaluation Tool
Software
From the software pack available to download
, run the
setup.exe
file that has this icon.
This will start the installation process.
Figure 2
– Installer Screen
Follow the on screen instructions and enter the information required.
As part of the installation process a check will take place to see if .NET Framework 4.5 is
present. If not, the setup routine can be cancelled and the .NET framework 4.5 can be
downlo
aded from Microsoft’s website.
A driver is needed for the STM32F303K8T6 microcontroller. This is included in the software
package.
3.2 Installing the ST Microcontroller USB Driver
The software zip file contains a folder called
en.stsw-link009.zip
. Extract the files and run
either the application
dpinst_amd64.exe
if you have a 64 bit system or
dpinst_x86.exe
if
you have a 32 bit system. This will install the USB driver for the ST microcontroller that is
connected to the SMD board.
Once the driver has been installed the USB cable can be connected between the SMD Board
and the computer.
Once connected the green light on the SMD board will be on constantly and the red light will
flash (the microcontroller is the inverse of this, red is on constantly and green flashes).
3.3
Installing .NET 4.5 Framework
If you do not have the .NET 4.5 framework installed on your computer then use the installer
provided (
dotnetfx45_full_x86_x64
) in the software package.