Yaesu ZCUT-9GR, Инструкция по эксплуатации

Страница: 15 / 16

Trouble Shooting
Before returning the machine for repairing, please check the followings.
If the machine still can not operate properly, stop using the machine
immediately and contact vendor for repair authorization.
Specifications
Power Requirement 100-240VAC 50/60Hz
Input Voltage Range
±
5%
Wattage 25W
Dimensions 116mm(W) x 140mm(H) x 213mm(D)
Weight 1.6 KG.
Body Material ABS
Tape Length 5mm ~ 999mm
Tape Width 6mm
~ 60mm
Feeding Speed 220mm/sec. (using Craft Tape)
Max. Outside Dia. of Roll 300 mm
Accessories Power Cord
2A Fuse [Built-In Inlet]
Separator / Guide Plate / Blade Oil
Remarks
◆
The specifications are subject to change without prior notice.
◆
The length of the tape may differ from the set length depending upon the type of the tape or its condition.
◆
Some types of tape available with the machine may not be cut depending upon conditions.
15
Tape curls excessively.
The length of the tape is
different from the set
length.
The BLADE can not move
smoothly.
After removing piece of
tape, the next piece does
not feed under AUTO
mode.
The POWER SWITCH is
on but the machine can
not run.
The machine is not grounded.
The ROLLER LOCK is disengaged.
The adhesive of tape is too strong.
The elasticity of tape is too strong.
The BLADE UNIT is not in a proper
position.
The mode is set MANUAL.
Some debris are covering on the
SENSORS.
The tape can not goes through the
SENSORS.
The tape has extremely low
reflectance.
The AC CORD is loosen.
The FUSE has been blown.
Check ground on cord.
Engage the ROLLER LOCK to apply tension.
Correct the setting after cutting several test pieces.
Check the BLADE UNIT and push down on the
housing firmly.
Set the mode to AUTO.
Remove the debris.
Use SEPARATOR to narrow the tape lesser than
25mm,
Do not bring strong illuminant close around the
SENSORS.
Some types of tape may not be used under AUTO
mode.
Check the AC CORD then plug in the outlet firmly.
Replace the FUSE.
Stop using the machine immediately even though
the FUSE is blown again after replace.