Yaesu ZCUT-10, Инструкция по эксплуатации, Страница: 8 / 16

8
◆
Make sure that Blue LED is off.
When the LED LAMP is flashing or turned on, press AUTO/MANUAL
MODE and turn off the LED LAMP.
◆
Press the START BUTTON once, the machine will feed-in a piece of tape
then cut it out based on your set length.
◆
To cut another piece, press START BUTTON again.
◆
Make sure that the Blue LED is flashing.
When the LED LAMP's lights are off, press AUTO/MANUAL BUTTON
and let the LED LAMP to flash.
◆
Press the START BUTTON once, the machine will feed-in a piece of tape
then cut it out based on your set length.
When that piece of tape is removed, the machine will feed-in another
piece then cut it out.
The machine will feed-in and cut a new piece of tape once the piece of
tape is remomved.
AUTO MODE
MANUAL MODE
◆
Make sure that DISPLAY indicating <cutting length>.
The cutting length is always indicates in some alphabets like A,b,C,d,E,F.
◆
Set the cutting length.
Set your needed length by using +/- BUTTON.
The cutting length is adjustable in between 5 mm to 999 mm.
Can set six different length by using SELECT BUTTON.
If you press +/- BUTTON in a short while, the length in changed to 1 mm.
And if you press +/- BUTTON longer, if shows fast foraward.
Caution
The actual length is differ from the displayed length depends on the type
of the tape and its condition.
When cutting short length of tape, the length may not cut consistently
or tape is jammed.
Try several test cuts to insure proper operation.
If pressing
－
BUTTON for setting from b to F, you will be able to set ZERO.
However, machine will not start while alarming even though pressing
START BUTTON.
Mode Setting
Set the Tape Length
START
START
CUT and STAND BY
CUT and STAND BY
REMOVE THE TAPE
REMOVE THE TAPE
TAPE FEED
TAPE FEED
FLASHING
LIGHT ON
INDICATE CUTTING LENGTH
SET THE CUTTING LENGTH
INCREASE NUMBER
DECREASE NUMBER
SET AUTO / MANUAL
SELECT
＋
－
A ～ F
AUTO
MANU
LIGHT OFF
BLUE LED LAMP
MANUAL MODE
MANUAL MODE
AUTO MODE
AUTO MODE