Yaesu FTM-350R - SOFTWARE UPDATE PROCEDURE 7110, Техническое дополнение

Страница: 10 / 67

14
FTM-350AR/E Technical Supplement
26.Increase the output level of the signal generator
up to +23 dB μ V.
27.Press the [ FWD
] key to save the new setting.
28.Press and hold in the [ ADJ
] key for one second,
to set the alignment Menu Item “
SMB U D SMB U D
SMB U D SMB U D
SMB U D
”.
29.Just repeat all steps above, in "SUB BAND".
TX Deviation
1. Inject a 1 kHz, 80 mV signal from the Audio Gen-
erator.
2. Set the transceiver frequency to 440.050 MHz.
3. Press the [
POW
] key to select "LOW".
4. Press the [ ADJ
] key to set the alignment Menu
Item “
DEV xxx DEV xxx
DEV xxx DEV xxx
DEV xxx
”.
5. Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the Deviation
Meter reading is 4.5 kHz (±0.2 kHz) (USA Ver-
sion: 4.2 kHz (±0.2 kHz).
6. Set the transceiver frequency to 146.050 MHz.
7. Press the
PTT switch to activate the transmitter,
adjust the left
DIAL
knob so that the Deviation
Meter reading is 4.5 kHz (±0.2 kHz) (USA Ver-
sion: 4.2 kHz (±0.2 kHz).
The following steps is USA Version only.
8. Set the transceiver frequency to 223.550 MHz.
9. Press the
PTT switch to activate the transmitter,
adjust the left DIAL knob so that the Deviation
Meter reading is 4.2 kHz (±0.2 kHz).
CTCSS TX Deviation
1. Set the transceiver frequency to 440.050 MHz.
2. Press the [
POW
] key to select "LOW".
3. Press and hold in the [ F
] key for two seconds to
change the [
SMART FUNCTION
] key category to
the " SQL " functions.
4. Press the [
TYPE
] key repeatedly, until the "
TONE
ENC " notation appears.
5. Press the [
TFRQ
] key, then rotate the right
DIAL
knob to select "100.0 Hz".
6. Press the [
ESC
] key to save the new setting.
7. Press the [ ADJ
] key to set the alignment Menu
Item “
MOD xxx MOD xxx MOD xxx MOD xxx MOD xxx
”.
8. Rotate the left DIAL knob to select "
MOD 10EH MOD 10EH
MOD 10EH MOD 10EH
MOD 10EH
".
9. Press the [ ADJ
] key to set the alignment Menu
Item “
CTC xxx CTC xxx
CTC xxx CTC xxx
CTC xxx
”.
10.Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the Deviation
Meter reading is 0.65 kHz ~ 0.75 kHz.
11.Set the transceiver frequency to 146.050 MHz.
12.Press the [
POW
] key to select "LOW".
13.Press and hold in the [ F
] key for two seconds to
change the [
SMART FUNCTION
] key category to
the " SQL " functions.
14.Press the [
TYPE
] key repeatedly, until the "
TONE
ENC " notation appears.
Alignment