Yaesu FTM-200DR, Руководство для продвинутых пользователей

Страница: 50 / 67

50
CONFIG
21 BEEP
Adjust the volume of the beep that sounds when a key is pressed.
1. Press and hold the [
F
MENU
] key

[ 21 BEEP ]

Press the DIAL knob
2. Rotate the DIAL knob to select the desired setting.
The Beep volume can be selected from 3 levels.
OFF / LOW / HIGH
22 BAND SKIP
Set the band selected when the [ BAND
GRP
] key is pressed.
1. Press and hold the [ F
MENU
] key

[ 22 BAND SKIP ]

Press the DIAL knob
2. Rotate the DIAL knob to selct the band to be set with a press the DIAL knob.
3. Rotate the DIAL knob to set “ON” (selectable) or “OFF” (not selectable).
AIR: OFF / ON
( 108MHz - 137MHz )
ＶＨＦ : OFF / ON
( 137MHz - 174MHz )
ＵＨＦ : OFF / ON
( 400MHz - 480MHz )
OTHER: OFF /
ON
( 174MHz - 400MHz , 480MHz - 999.995MHz )
23 RPT ARS
Set the auto repeater shift function.
1. Press and hold the [
F
MENU
] key

[ 23 RPT ARS ]

Press the DIAL knob
2. Rotate the DIAL knob to select the desired setting.
AUTO The auto repeater shift function is enabled.
OFF The auto repeater shift function is disabled.
NOTE : This item is registered in the custom function menu by factory setting.
24 RPT SHIFT
Set the direction of the repeater transmit shift setting.
1. Press and hold the [
F
MENU
] key

[ 24 RPT SHIFT ]

Press the DIAL knob
2. Rotate the DIAL knob to select the shift direction setting.
OFF
The transmit frequency will not shift.
- The transmit frequency will shift down.
+ The transmit frequency will shift up.
25 RPT SHIFT FREQ
Set the repeater transmit shift offset frequency.
1. Press and hold the [
F
MENU
] key

[ 25 RPT SHIFT FREQ ]

Press the DIAL knob
2. Rotate the DIAL knob to select the desired repeater transmit shift offset frequency.
The offset can be set at 0.05 MHz intervals between 0.00 MHz and 99.95 MHz.
The default setting differs depending on frequency.