19
Preparation
Installing the Antenna
1. Turn the antenna clockwise until it is secured.
•
Do not hold or twist the upper part of the antenna
when installing or removing it. To do so may break the
conductors inside the antenna.
•
Do not key the transmit without installing the antenna.
The transmitter components may be damaged.
Hold the thick base
of the antenna
Attaching the Accessory Protective Cap/Belt Clip
z
Attaching the Belt Clip
1. Attach the belt clip on the back of transceiver using the
supplied screws (two).
Be sure to use the supplied screws when attaching the belt
clip. If any other screws are used, the belt clip cannot be
secured firmly to the battery pack and the transceiver may
drop off together with the battery pack; the transceiver and
battery pack may fall off, causing injury, breakage and other
damage.
z
Attaching the Protective Cap
If the belt clip is not used, install the protective cap to cover
the belt clip attaching screw holes on the battery pack.
Installing the Battery Pack
1. Insert the bottom tabs of the battery pack in the slots on
the back side lower part of the transceiver.
2. Push the battery in until the battery latches click securely.
Charge the battery pack before using the transceiver for the
first time after purchase, or when it has not been used for a
long period of time.
Caution
: Risk of explosion if battery is replaced by an
incorrect typ. Dispose of used batteries according
to the instructions.
Battery Latches
z
Removing the Battery Pack
1. While pressing down the latches, remove the battery pack.
