FT-991 O
peraTing
M
anual
(WireS-X e
diTiOn
)
Page 10
C
onneCTing
To
a
n
ode
or
r
oom
on
The
i
nTerneT
in
a
nalog
m
ode
When connecting to a local node which is an analog station, use the optional DTMF microphone “MH-36E8J”.
1. Connect the optional DTMF microphone “MH-36E8J” to the
transceiver.
2. Set the communication mode to FM.
After pressing the
MODE
button, touch “FM” on the screen, then
press the
MODE
button again.
3. Tune to the frequency of the local node you want to connect to.
4. While pressing
[PTT]
on the microphone, press the buttons (
[#]
,
[0]
to
[9]
) on the microphone to transmit the access code.
e
xample
:
[#]
→
[2]
→
[0]
→
[5]
→
[1]
→
[1]
5. Release
[PTT]
, and keep the transceiver in reception mode for about
ten seconds.
When the connection is successfully established, you will be able to
hear audio.
T
ip
:
The ID information of the connection destination does not appear.
d
isConneCTing
from
The
n
ode
or
r
oom
y
ou
a
re
C
onneCTed
To
in
a
nalog
m
ode
1. While pressing
[PTT]
on the microphone, press the buttons on the
microphone to transmit #99999 (disconnection command).
Disconnects the node or room.
T
ip
:
You can disconnect from some specific nodes just by transmitting
[*]
.
C
ommuniCaTing
wiTh
o
Thers
1. Press
[PTT]
on the microphone.
The transceiver switches to transmit mode.
2. Speak into the microphone.
Speak into the microphone in your normal speaking voice while
keeping it about 5 cm away from your mouth. Do not continuously
transmit over an extended period of time to reduce the risk of
overheating, malfunction, or injury.
C
auTion
:
Maximum continuous TX: three minutes
3. Release
[PTT]
.
The transceiver switches to receive mode.
c
ommunIcatIng
u
sIng
WIrEs-X
