REGULAR MEMORY
Yaesu FT-8900R Operating Manual Expanded Edition (courtesy of W5JCK)
Page 36 of 77
Delete a Memory
With 808 memories available (except memory channel #1), there are frequently situations
where you may desire to delete certain memorized frequencies. The procedure for deleting a
channel is quite simple:
1.
If operating in the
VFO
mode, press the
key momentarily to enter the
Memory
mode.
2.
Press and hold in the
SET key
for ½ second, then rotate the
DIAL
knob to
select the memory channel to be deleted. (Note that memory channel #1 may not be
deleted.)
3.
Press the
Main
band
key momentarily. The display will revert to memory channel
#1. If you rotate the
DIAL
knob to the location you just
Masked
, you will
observe that it is now invisible.
0.
Once deleted, the channel data cannot be recovered.
Set a HOME Channel for an Operating Band
A special one-touch
HOME
channel is available (one for each of the six operating bands), to
allow quick recall of a favorite operating frequency on each band. To store a
HOME
channel:
1.
Select the desired frequency while operating in the
VFO
mode on the
Main
band. Be
sure to set up any desired
CTCSS
or
DCS
tones, as well as any desired repeater offset.
The power level may also be set at this time.
2.
Press and hold in the
SET key
for ½ second. A memory number will appear
(blinking) on the display.
3.
While the memory channel number is blinking, press the
key. The
frequency and other data will now be stored in the special
HOME
channel register.
0.
You may repeat this process on the other operating bands.
To recall the
HOME
channel, just press the
key while operating either in the
VFO
or
Memory
mode.