Page 88
FT-450D O
PERATION
M
ANUAL
C
LONING
You can transfer all data stored in one transceiver to another set by utilizing the handy “Cloning” feature. This
requires a user supplied cloning cable, which connects the
CAT
jacks on the two transceivers, as shown below.
To clone from one transceiver to another, use the following procedure:
1. Insert the D-SUB 9pin cross cable (User Supplied)
into the
CAT
jack of each transceiver.
2. Turn both transceivers off, then press and hold in
the [
MODE
] and [
MODE
] buttons on each ra-
dio while turning the power on again. The “
cLonE
C.S-SND
” notation will appear on the display.
3. On the “Source” radio, press the [
C.S/VOICE
] but-
ton.
4. Data will now be transferred to the “Destination”
radio from the “Source” radio.
When the clone completes successfully, “
CLonE
SENDING
” is displayed on the display.
If there is a problem during the cloning process,
“
Error
” will be displayed. Check your cable con-
nections and try again.
5. If cloning is successful, turn the “Destination” ra-
dio off, and “
cLonE C.S-SND
” notation will reappear
on the “Source” radio.
6. Turn the “Source” radio off.
7. Remove the clone cable. The channel and oper-
ating data for both radios are now identical. Both
radios may be turned on now for normal opera-
tion.
N
OTE
:
The cloning operation cannot be performed between
the FT-450D and FT-450.
INPUT
DC 13.8V
22A
ANT
GND
EXT
SPKR
CAT
LINEAR
TUNER
DATA
INPUT
DC 13.8V
22A
ANT
GND
EXT
SPKR
CAT
LINEAR
TUNER
DATA
D-SUB 9pin cross cable (User Supplied)
[
C.S/VOICE
] button
“Destination”
“Source”
Press the [
C.S/VOICE
] button
[MODE
] and [MODE
] buttons
[
ON/OFF
] button
