background image

13.4 Reduce signal generator level until the unit squelches.  

The difference between generator levels for “open” vs. “squelched” should 

be 1-5dB.  

The squelch sensitivity should be between 8 to 16dB SINAD. 

 
 
 

14. Audio output power and distortion  

 
14.1 Increase signal generator level to -47dBm. 
14.2 Set Ext Load R to 16ohm. 
14.3 With 1.5kHz deviation at 1kHz modulation, set volume for maximum audio.  

Audio power should be between 80mW and 100mW across sSP 

and -SP. 

 

Page 4 of 4

Содержание CHATNOW 75028 Series

Страница 1: ...HP8920A 3 Voltage Regulator Test 3 1Connect a voltmeter to output of regulator TP11 VCC and measure the voltage The DC value must be between 3 45 to 3 58Vdc 4 Low_Battery Detect Alignment 4 0 Connect a voltmeter to TP10 LOW_BATT 4 1 Adjust power supply to 4 80Vdc 10mV 4 2 Select one resistor from R112 to R114 until the voltmeter reading is close to 2 25Vdc 40mV Unit will beep 5 Battery ICON Level ...

Страница 2: ...requency is equal to the channel frequency with a maximum error 500Hz VC1 is located near the crystal unit of X1 8 Transmitter Output Power Check No alignment needed 8 1Set unit to channel 1 8 2 Press the PTT switch so unit is in transmit mode 8 3 Transmit power should be below 160mW ERP 8 4 Set unit to channel 14 8 5 Press the PTT switch so unit is in transmit mode 8 6 Transmit power should be be...

Страница 3: ...8920 to antenna test point 11 2 Set the deviation meter to read peak to peak maximum deviation 11 3 Set Filter 1 to 50Hz HPF Set Filter 2 to 15kHz LPF 11 4 Press RIGHT KEY to send DATA The modulation meter should read 1 5Khz 12 Receiver Alignment 12 1 Set Filter 1 to 300Hz HPF Set Filter 2 to 3kHz LPF 12 2 Set the output level of the RF signal generator for 47dBm The generator should be set for 1 ...

Страница 4: ... 1 5dB The squelch sensitivity should be between 8 to 16dB SINAD 14 Audio output power and distortion 14 1 Increase signal generator level to 47dBm 14 2 Set Ext Load R to 16ohm 14 3 With 1 5kHz deviation at 1kHz modulation set volume for maximum audio Audio power should be between 80mW and 100mW across speaker SP and SP Page 4 of 4 ...

Отзывы: