11
12
Icon
No
1
2
3
4
5
6
7
8
9
10
11
12
13
Name
IMotor fault
Operational readiness
Controller failure
Turnlebar fault
High beam
Speed display
Gear display
Right steering
Odometer
Energy recovery display
Left steering
Battery percentage display
Low voltage indicator light
Instruction
When the motor fails, the indicator lights up
When the P gear of the scooter is released and the scooter speed is 0,
the indicator lights up;
When the controller fails, the indicator lights up;
When the throttle fails, the indicator lights up;
When the high beam is turned on, the indicator lights up;
Show the current speed
Show the current gear
Push the turn signal switch to the right, and the indicator light flashes;
Display the total mileage after startup, and the short mileage after 5s
When energy recovery is detected, the recovery value is displayed；
Push the turn signal switch to the left, and the indicator light flashes;
Displays the percentage of battery power remaining
When the voltage is too low, the indicator lights up.
③
①
②
④
Combination switch
Left combination switch
1. High and low beam light: move forward to turn on the high beam, move back to switch to low beam.
2. Left/right turn switch: Push the switch handle left or right to turn on the corresponding position turn signal, sending out a
continuous flashing light signal. At the same time, the instrument panel sends out a green turn indicator signal.When the switch
handle is pushed to the middle position, the turn signal can be turned off.
3. P-gear switch: When the scooter is powered on and the side brace is up, press the P-gear switch to remove the P-gear
state;Short press once again to enter the state of P-gear ; Long press P-gear to switch meter from metric system to imperial
system.
4. Horn switch: press the horn switch, the horn prompt sound can be issued.
① Combination switch
② Turn left/right switch
③ P mode switch
④ Horn switch
