12
FCC Compliance Statement:
15A Battery Charger and Maintainer
Model: AC532713 / Responsible Party: YADA
2975 Red Hill Ave., Ste. 100, Costa Mesa, CA 92626 / Tel: 866-294-9244
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause
undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications or change to this equipment. Such modifications or change could void the user’s
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
OPERATING INSTRUCTIONS CONT.:
2975 Red Hill Ave., Ste. 100, Costa Mesa, CA 92626
Mon - Fri, 8AM - 5PM (Pacific Time)
Tel: 1-866-294-9244 (English only)
©2021 ADC Solutions Auto, LLC. All rights reserved.
www.letsyada.com
Made in China
CAN ICES-3 (B)/NMB-3(B)
ML-532713_V1
viii)
Push Mode
(for 12V Lead-Acid battery only) is designed for charging
batteries with voltage 0.5V to 3.75V. At Standby mode with battery
clamps are connected to 12V Lead-Acid battery, if the battery voltage is
measured at 0.5V to 3.75V, both LEDs light on. Press and hold
MODE
button for 3 seconds to enter Push Mode. Connect battery clamps to
vehicle battery and the battery will be charged with maximum current of
0.5A until the voltage is up to 3.75V and it will enter the 12V Lead-Acid
Battery Mode for charging onwards or it will return to Standby mode and
stop charging after 5 minutes if 3.75V can not be reached.