Verifying the magnetic alarm connection?
When you have activated, the small LED-light on the accessorie should blink
rappidly when the connection is OK. If connection failed it will only turn the LED-
light on once for aprox 1-2 sec. If you do not get any response in the app, try again.
When activation is successfull you are ready to mount the magnet alarm. Please
wait approx 2 minutes before you connect another alarm accessory to the G32
system.
Mounting
The IR-sensor sends an alarm when it detects heat emission from a person. See pic-
ture for detection angle. You need to open up the product to be able to mount the
product with screws from the inside. Release the screws, open up the product and
then remove the circuit card. Don’t place the IR-sensor in places where you have
strong sunlight which might activate the sensor.The signal from the sensor part to
the alarm unit will pass through walls and a big variety of materials. However, check
the signal before mounting. After the accessory has been connected to the alarm
you are able to push the button on the circuit card fast. If the LED light on the cir-
cuit board is flashing this means that the distance range is enough. You will receive
alarm directly in your phone if the battery in the accessory has to be changed.
A. Take away the upper
plastic cap to turn off
the lamp.
B. Move the lower
plastic cap one step
up and put it over the
two sticks to increase
the sensitivity of the
sensor.
Top view 110°
Side view
2.3
1 2.5 8 15
(The illustration above is showing the field of view. Unit: meter.)
