. INSTALLATION
. INSTALLATION
L1 L 2 U N L + U N L -
Slave Indoor Monitor
Master Indoor Monitor
Outdoor Camera
Door Lock
1.Wiring Diagram
1) For expandable system, please make sure it is master indoor monitor rather
than slave indoor monitor to co nnect with outdoor came ra. There is always 1
master indoor monitor only in a system, the oth er slav e indoor monitors should
be connected from the master indoor monitor.
L1
L 2
S 2
S 1
L1
L 2
S 2
S 1
L1
L 2
S 2
S 1
Slave Indoor Monitor
1) Select a mounting location to an AC outlet but the monitor cannot be exposed to
2.Monitor Unit
3) The above figure in dotted line illustrates the standard system, that is 1 camera & 1
monitor. Maximum 1 camera can expand to work with 3 monitors.
2) This system is of 2-wire non-polarity technologies. The connection of terminals
can ignore their
“
+/-
”
polarity.
dirt, direct sunlight(or other strong light), direct moisture conditions. After determining
the location, attached mounting bracket securely to the wall.
3) Insert and fix the plug bolts in the 4 small holes, then at tach th e mount ing bra cket
to the wall and fix with 4 self-tapping screws.
2) Drill a hole in the center area of the bracket just big enough for the electrical wiring
to pull through. And drill 4 small holes for plug bolts.
Notes:
3. Camera Unit
The monitor is compatible with several camera units (ODS-J/ODS-5/ODS-S
/ODS-2
are optional.), please verify the model no. before installation and follow
correct directions. The recommended location of camera unit is at the height
150~170cm from central part of Camera to the floor(for reference only).
1) ODS-J
1) ODS-J
Drill a hole in the center area of the bracket just big enough for the electrical
wiring to pull through. And drill 2 small holes for the plug bolts.
Plug Bolt
Bracket
Self-Tapping Screws
Hook Holes
1
.5
-1
.7
m
Notes: Do not expose the camera unit to direct
sunlight and be sure it is shield from storm rain. The
background of visitors may be affected by street lamp
and other strong light, you can mount some lamps to
highlight for clearer images of visitors.
Cable
4) Connect well the wires from Wiring Terminal and pull through the central hole
which connect to the camera unit.
.
Insert and fix the plug bolts in the 2 small holes, then attach the mounting
bracket to the wall and fix with 2 self-tapping screws.
Pull the wiring which connect to Monitor Unit through the central hole and connect
5) Attach the wired monitor unit to the bracket by setting the monitor over the four
bracket hooks and sliding it down.
well with Terminals L1&L2. Also prepare 2 wires to connect with Lock Connectors
