YAAHKIEH MC40, Руководство пользователя, Страница: 10 / 16

7
To start the machine
Emergency switch is pop-up
Engine switch is of 'on' position
Fuel supply is open
Open Air intake to allow fresh air
Slowly pull the recoil rope 3-5 times to get fuel supply system filled
Then pull with strength till engine is fired
Keep engine running at idle speed for 1 minutes
Slowly push the throttle bar to the 'Rabbit'
Keep the engine at full RPM (revolution per minute) while working to protect machine from clogging.
*NOTE*
This machine is only for the use that has been designed. To use it for other purpose may cause injure to people or
damage to machine.
Put the branches into the hopper and when they are pulled in and let them go. The branches will be pulled in
automatically.
While chip thick ones, pay attention the engine and keep it maintained.
Trim the side branch over 3cm in diameter, before put it into hopper separately. Long branches and thick branches
will shake and might slash into your face, make sure you hold it firmly and always wear the face protection.
TO STOP MACHINE:
Use the emergency switch immediately if there is urgency.
Normally, the engine should be allowed to idle status by turning to(TURTLE) first for a minute then switch off the
engine
If you want to stop chipping let the machine run for a while, to chip and eject all debris left which could jam the
rotor while you want to start the machine next time.
MACHINE GET JAMMED
If the machine gets stuck by pieces of input. do as follow:
Stop the machine, disassemble the plastic bearing cover, and turn the rotor a few degrees by rotor spanner specially
made.