
5
Before use: external temperature sensor probe into the left of the controller
temperature probe interface probe placed in similar battery temperature. (Line
extension must be built-in devices of the external temperature probe coextensive
Otherwise, the controller will control parameters of the temperature compensation of
the error
6
Warning: In order to prevent accidents from occurring, install: non-professionals can
not be engaged in loading and unloading operations
3:LCD operating interface description
Charging
Charging Fault
Is discharging
Discharge failure
A
℃
A
%
Solar
charging
current
Ambient
temperature
Load current
Battery capacity
PV OFF
V
Load OFF
V
Load ON
V
Stop battery is fully charged
voltage (can be set)
Battery under voltage stop
the supply voltage (can be
set)
Under voltage battery
Load voltage is switched
on again
Evening
H
Load output state is set:
Set to 00H, said that under the light control mode, after dark (dusk)
open load; after dawn (Dawn) load to stop working.
Set to: 24H represents the load has been open until the battery voltage
protection automatically disconnects the load;
Set time: 01H to 23H, said under the next delay lighting control mode,
the load is loaded loaded loaded automatically after a delay before
disconnecting a few hours in the evening and applications. (Expressed
as the number of time delay)
Interval
H
An interval of time setting (set this time, Dawn to Evening; to stop working
load time)
Set to: 00H indicates Evening to Dawn without the interval or intervals of 0H
Set to: 01H to 24H represents Evening to Dawn stopping power load time
(corresponding to the numbers indicate the length of time delay).
Dawn
H
Load output state is set: the length of the second opening hours or workload;
Set to: 00H means no load open or the length of time the load power 0H;
Set: 01H24H said opening a load length of time; (numbers indicate the
length of time corresponding to the open load).