5
Lower the filament spool
holder on the back side of
the printer until horizontal.
Open the hold-open
component and take out
the print bed.
Place the assembled
filament spool (with the
spool ring) on the spool
holder.
Stick the bed tape onto the
print bed. (align center)
Note: The bed tape is reusable,
and only needs to be replaced
when it is worn out.
The filament will load
better when the tip of the
filament is cut at a 45°
angle.
01
04
02
05
03
Remove Print Bed
Note
•
The filament will load better when the tip of the filament is cut at a 45° angle.
•
When the printer is not in use, raise the filament spool.
•
If the room temperature is below 25℃ / 77° F, apply some glue to the bed tape for better part
adhesion.
45°
Printer Setup
Installing the Filament