6
XYZ Machine Tools
ProtoTRAK KMX CNC control, Safety and Quick Start Guide
CBB PWR
: This connector is not used on Euro KMX models. It is internally connected to 110VAC.
DO NOT plug anything (else) into this connector.
UPGRADE-AUX:
This connector is only used on some KMX, PT3 upgrades. DO NOT plug anything
else into this connector.
SPDL SW BOX:
This connector is not used on Euro KMX models. It is internally connected to
110VAC. DO NOT plug anything into this connector.
UPGRADE SW BOX:
This connector is not used on Euro KMX models. It is internally connected to
110VAC. DO NOT plug anything into this connector.
Warning: never plug/unplug any cables with the power on
(other than USB) as this may damage the pendant!
Powering Up the System
To turn on the machine, rotate the power switch on the Electrical Cabinet to the On position. Then
turn on the pendant using the On/Off switch on the back.
The control will go through its boot up sequence. When it is finished, the following screen will
appear.
Press the CHECK SYSTEM select key.
The machine will always power up in an Estop condition, Press the POWER ON button when you are
ready to start moving the machine. Many control functions, like programming can be done with the
machine in the E-stop condition (which saves you lube oil).
Please refer to the Operating Manual for full operating instructions.
Turning off the System
Press Mode, Restore, Shut Down and finally answer Yes.
Turn the power off at the back of the pendant. Turn the power off at the machine electrical cabinet.
The ProtoTRAK control should be shut off, at a minimum, every week. Failure to reboot may cause
the control to run slowly.
Maintenance
Please refer to the schedule on the machine and in the service manual for important maintenance
activity.
