Xytronix Research & Design ControlByWeb X317, Руководство пользователя

Страница: 15 / 68

X-317™ Users Manual Installation and Connections
2.6 Establishing Communications for Setup
In order to configure the X-317 with the web browser interface, the X-317 must be connected to an
Ethernet computer network. This can be done by one of two methods:
Method 1– Temporarily change the IP address of a connected computer to the match the default IP
address used by the X-317.
-or-
Method 2 – Assign a temporary IP address to the X-317 to work on an existing network.
Note: If multiple ControlByWeb™ products are used on the same network, install one at a time and set
the IP address of each unit before connecting the next unit to the network. This avoids having multiple
devices being installed on the network with the same factory default IP address at the same time. If this
approach is used, be sure to clear the arp cache after disconnecting each unit (
arp -d
).
2.6.1 Method 1: Assign a Temporary IP Address to Configuration Computer
By default, the X-317 comes from the factory with an IP address of 192.168.1.2. Communication with the
X-317 may be established by assigning an IP address to the configuration computer so that it is on the
same network as the X-317 (for example, the configuration computer could be assigned to
192.168.1.50)
The following example is for those running the Windows-8 operating system:
1.
Apply Power, wait 15 seconds for the X-317 to become operational, and then connect the Ethernet
cable.
2.
Open the Windows 8 start screen.
3.
Type “ Control Panel” and press enter (the search box opens automatically when you begin typing).
Xytronix Research & Design, Inc. Page 15