Operating Instructions
Thank you for purchasing the XYTRONIC Electronics T 1976 Soldering Station .For ease
of use and maximum longevity of this tool,please read these instructions carefully and
refer to Fig.I below before commencing use of the T 1976 for the first time.
WARNING:
This appliance is not intended for use by young children or infirm persons
without supervision.
FIG . 1
Initial set-up
After removing the T 1976 from its protective cardboard packaging,check the base
unit,soldering pencil and cables for any signs of damage.If any damage is evident,do not
plug it into an AC outlet ,but instead contact the place of purchase to arrange for
correction of the damage.
Once you have inspected the Soldering Station and it appears to be free of damage,refer to
Fig.2 below and check that the knurled nut from the tip retaining assembly has been
tightened moderately to securely hold the soldering tip in place.
Moisten the cleaning sponge with water,and place it in the well on top of the base unit.
FIG..2
Plug the soldering station into an AC outlet and turn the Temperature Control to slightly
above the 340 degrees position .Depress the power switch on the front panel of the T 1976
to the “ON”position and allow about 2-3minutes for the soldering tip to heat to operating
temperature.
