7
the user to input the mode lock password “010” (fixed). If the user inputs the same
number as “010”, the unit will enter the modes selection procedure, otherwise, the
unit will be back from the current mode automatically.
2.
After the unit enters the Modes selection, the LED will display “F-0”and flash.
Press “▲”or “▼” key to select modes. If the user doesn’t press “▲” or “▼” key
within 15 seconds or press “SET” key one time, then the unit will be immediately
back from the Parameter Set status.
For example: F-0 → F-1 → F-2 → F-3
↑ ↓
← ← ← ←
3.
Password Setting:
When the LED displays “F-1” and flashes, press “SET” key one time and the unit
enters the Password Set status. At this moment, the LED displays the pre-set value.
Press “▲” or “▼” key to change password set value. If the user sets “000” that
means the unit will be under the status of no password. If the user sets “100” then
means the unit will be under the password status. Press “SET” key once to finish
password setting and the unit will backup mode, the user can continue set other
modes or back from the setting mode.
4.
Temperature Correction Setting
Press “SET” key once when the LED displays “F-2” and flashes that the unit enters
the Temperature Correction Mode. At this moment, the LED displays preset
correction value.
A: Operation of Centigrade temperature correction
（Range +99℃~-99℃）
Press “▲” or “▼” key to change the temperature correction value.The first digit
“— ” in LED display means minus (actual temperature is down), “No display”
means plus (actual temperature is up).
Example for temperature correction:
The current set temperature value is 300
℃,
however, the actual temperature is only
290
℃
. So it needs to correct by +10
℃
. Correction method: if the current correction
value is 00 or -00; then change it to 10. If the current correction value is -20, then
change it to -10. If the current correction value is 20, then change it to 30.
5.
Sleep Mode Set
Press “SET” key one time when the LED displays “F-3” and flashes, the unit enters
the Sleep mode status. At this moment, the LED displays the pre-set value. Press
“▲” or “▼” key to change the set value. If set value reads “000” that means the unit
set in “Sleep” mode releasing status. If the display read “100” that means the unit
set in “Sleep” mode. Press “SET” key once to finish the sleep mode setting, then the
unit automatically backup. The user may continue set other modes or back from
current set mode.
Please note the manufacturer original design will keep in “Free” status without
