Step 3:
• On the bottom supply
roll, grasp the laminated
starter section by the
leading edge film.
• Route over the bottom
idler bar adjacent to the
lower rubber roller.
• Make sure the film is
inserted squarely. Rotate
the handle 1/4 turn in the
direction of the arrows.
Step 6:
• Continue to crank film through the
machine until it is aligned and wrinkle-free.
• Trim off excess film by pressing down
on the blade holder and sliding in
either direction.
Step 7:
• Replace the top cover.
• Close the lower access door.
• Install feed tray completely by
aligning the support posts in the
grooves located in the sides
of the machine.
When done correctly, the film layers should be aligned and wrinkle-free after
18” (45cm) of material has exited the machine.
Step 4:
• Make certain the lower
film is tight. If necessary,
rotate the supply roll
in the direction of the
arrows until the film is
taut.
• Grasp the film from the
upper supply roll and
adhere it to the film on
the lower supply roll.
By carefully aligning
the edges, keeping the
film tight and avoiding
wrinkles, film waste
will be minimized.
Step 5:
• Rotate the handle to pull
the supplies through the
machine.
• Ensure that the film exits
between the blade bars.
• Just before the top film
becomes tight again,
insert a small piece of
cardstock between the
rubber rollers. This will
help to minimize waste
and ensure the film exits
between the blade bars.
