Remove the XM1255 and crank handle from the packaging. Install the crank
handle by carefully threading it clockwise into the threaded opening in the side
plate until tight. When tightening the handle, hold the rubber rollers inside the
machine, to tighten as snug as possible.
Setting Up
Loading Supply Rolls
Input
Tray
Slide input tray
out of machine by
pressing tabs on each side.
1
With top cover open, lift
out used cartridge com-
pletely. Replace cartridge with
new one.
Make sure label is up
and viewable from top input
side of machine.
2
From the input side, insert
starter card into machine
between the substrates to start
material through the rollers. Turn
the handle of the machine in the
clockwise direction. This will
advance the material.
3
Advance the film through
the machine until the film is
aligned and wrinkle free.
This may take 6 – 10 inches.
Reinsert the tray. Be sure it
"snaps" into place.
4
Press down the orange blade
holder and slide it in either
direction to trim excess film.
5
