Xylem NiCaVis 705 IQ, Руководство по эксплуатации, Страница: 21 / 58

NiCaVis 705 IQ
Commissioning
21 ba75953e03 05/2017
3.4.4 Settings for virtual sensors
Carrying out
settings
Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu (setting table) of the sensor. The
procedure is described in detail in your IQ S
ENSOR
N
ET
system operating
manual.
Default values are marked in bold.
Quit
- The display switches to the next higher
level without storing the new settings.
Menu item Settings Explanations
Menu item Settings Explanations
Measuring mode
(NitraVis 705 IQ)

NO3-N

NO3
The measured parameter is displayed
in the selected citation form.
Measuring mode
(CarboVis 705 IQ)

COD spectr., total

COD spectr., dissolv

TOC spectr., correl.

BOD spectr., correl.

DOC spectr., correl.

SAC 254, total

SAC 254, dissolved

UVT 254, total
*

UVT 254, dissolved
*
The measured parameter is displayed
in the selected citation form.
Measuring location Outlet
(permanently set)
Measurement location or application of
the sensor.
The setting is done in the setting menu
of the relevant main sensor.
Measuring range
- Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
).
Cal - # raw value 1
Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission
-
ing.
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2