en – Original instructions
29
7.2 Functions of push buttons
Table 14: Functions of push buttons
Push button
Function
1.
Main Visualization (see par. 7.4.1): decrease the required value related to the
selected control mode.
2.
Parameters Menu Visualization (see par. 7.4.2): decrease the parameter index
visualized.
3.
Parameters Editing/Visualization (see par. 7.4.2): decrease the displayed parameter
index.
4.
Zero Pressure Autocalibration (see par. 7.5, P44): perform autocalibration of pressure
sensor.
1.
Main Visualization (see par. 7.4.1): increase the required value related to the selected
control mode
2.
Control Mode Selection: change control mode.
3.
Parameters Menu Visualization (see par. 7.4.2): increase the displayed parameter
index.
4.
Parameters Editing/Visualization: increase the parameter value.
5.
Zero Pressure Autocalibration (P44): perform autocalibration of pressure sensor.
1.
Main Visualization: START/STOP the pump
2.
Parameters Menu Visualization: switch to Parameters Edit Visualization.
3.
Parameters Edit Visualization: save the parameter value.
long press
Main Visualization: switches to Parameter Selection.
Parameters Menu Visualization: switches to Main Visualization
and
Main Visualization: switch between units of measure Speed and Head (see par. 7.3.4).
and
Main Visualization: switch between units of measure Speed and Head (see par. 7.3.4).
7.3 LEDs description
7.3.1 Power LED (2)
When the
POWER
(green) LED is lit, the pump is supplied with power and the electronic devices
are operative.
7.3.2 Status LED (5)
•
If the STATUS LED is not lit, then the pump is stopped or disabled (the pump motor is not
running).
•
If
the
STATUS
(green) LED is lit, then the pump is running.
•
If
the
STATUS
(orange) LED is lit a non-blocking alarm is detected while the pump is stopped.
•
If
the
STATUS
(orange) LED is lit alternate with
STATUS
(green), a non-blocking alarm is
detected while the pump is running.
•
If
the
STATUS
(red) LED is lit, a blocking error is detected and the pump is stopped (the pump
motor is not running).
7.3.3 Speed LED bar (4)
The Speed LED bar is composed by 10 LEDs and each of them represents a % step (from 10%
to 100%) of the interval, between the absolute minimum (P27) and maximum (P26) speed
parameters values.
