IQ SensorNet MIQ/IC2 Module
QUICK START GUIDE
Quick Start Guide
YSI Municipal Water
•
XA00166
Overview
The MIQ/IC2 current input module provides two 0/4 - 20 mA current
inputs for IQ SensorNet and thus enables to connect external sensors
via their current output. Measured values of the external sensors can
be displayed, recorded and processed like the measured values from
IQ SensorNet.
Examples:
• Connecting flow meters to IQ SensorNet
• Connecting level meters to IQ SensorNet
• Connecting analyzers to IQ SensorNet
• Connecting pressure sensors to IQ SensorNet
Scope of Delivery:
• MIQ/IC2 module
• 4 x cable glands (clamping range 4.5-10 mm) with seals and blind
plugs
• 4 x ISO blind nuts M4 with suitable cheese-head screws and plain
washers
• 2 x countersunk screws M3x6 to close the module lid (+ 2
replacement screws)
• 1 x contact base with fixing screws
Materials Required
To set up the MIQ/IC2 module you will need the following tools:
• Cable stripping knife
• Wire stripper
• Phillips screw driver
• Small screw driver
• Cable
TABLE OF CONTENTS:
1. Setup
2. Wiring
3. Configuration
Figure 1:
MIQ IC2 Module
