Xylem FLOJET 3526 Series Скачать руководство пользователя страница 4

Winterizing

Sanitizing

SYSTEM CARE AND MAINTENANCE

Allowing  water  to  freeze  in  the  system  may  result  in
damage to the pump and plumbing system. 

Non-Toxic antifreeze for potable water may be used with
Flojet pumps. Follow manufacturers recom menda  tions. 

Refer to coach or equipment manufacturers instructions
for their specific winterizing and drainage procedures.  

Do not use automotive antifreeze to winterize potable

water systems. These solutions are highly toxic and may
cause serious injury or death if ingested. 

1. Drain  the  water  tank.  Open  tank  drain  valve  and

plumbing  drain  valves  if  applicable.  You  may  use  the
pump to drain the tank by opening all the faucets in the
system.  Allow  the  pump  to  operate  until  the  tank  is

empty. Do not operate the pump more than 15 minutes
continuously. 

2. Open  all  faucets  and  flush  the  toilet  to  purge  all  the

water  from  the  pump  and  the  plumbing  system.  Run
the pump until no water is coming through the faucets.

Turn power to the pump off. Be sure that all the water
from the drain lines are drained. 

3. Remove quick connect inlet and outlet fittings from the

pump  and  turn  the  pump  on  to  pump  out  remaining
water from the pump head. Be sure to have a catch pan
or a rag  under the pump to prevent water from spilling

on to the RV. Turn the pump off once the plumbing is
empty. Leave the fittings disconnected from the pump
until the system is ready to be used again. Make a note

on your tank filler that the plumbing is not connected. 

4. Be sure that all faucets are left open to protect against

damage to the plumbing.

Portable water systems require periodic maintenance to
deliver  a  consistent  flow  of  fresh  water.  Depending  on

use  and  the  environment  the  system  is  subject  to,
sanitizing  is  recommended  prior  to  storing  and  before
using the water system after a period of storage.
Systems with new components, or ones that have been
subjected  to  contamination,  should  also  be  disinfected
as follows:
NOTE:  The  sanitizing  procedure  is  in  conformance  with
the approved procedures of RVIA ANSI A119.2 and the
US Public Health Service.
1. Use of the following methods to determine the amount

of common household bleach needed to  sanitize the
tank.

1. 

A) Multiply  “gallons  of  tank  capacity”  by  0.13;  the

result  is  the  ounces  of  bleach  needed  to  sanitize
the tank.

1. 

B) Multiply “Liters of tank capacity” by 1.0; the result

is  the  milliliters  of  bleach  needed  to  sanitize  the
tank.

2. Mix into solution the proper amount of bleach within a

container of water

3. Pour  the  solution  (water/bleach)  into  the  tank  and  fill

the tank with potable water.

4. Open ALL faucets (hot and cold) allowing the water to

run until the distinct odor of chlorine is detected.

5. The  standard  solution  must  have  four  (4)  hours  of

contact  time  to  disinfect  completely.  Doubling  the
solution concentration allows for contact time of one
(1) hour. 

6. When  the  contact  time  is  completed,  drain  the  tank.

Refill with potable water and purge the plumbing of all
sanitizing solution.

WARRANTY

FLOJET warrants this product to be free of defects in material

and/or workmanship for a period of two years after purchase by

the  customer  from  FLOJET.  During  this  two  warranty  period,

FLOJET will at its option, at no charge to the customer, repair or

replace  this  product  if  found  defective  in  material  or

workmanship, with a new or reconditioned product, but not to

include costs of removal or installation.
This is only an overview of our Limited Warranty. If you would

like a copy of our warranty, please call or write FLOJET.

RETURN PROCEDURE

Prior to returning any product to FLOJET, call customer service

for an authorization number. This number must be written on the

outside  of  the  shipping  package.  Place  a  note  inside  the

package with an explanation regarding the reason for return as

well  as  the  authori zation  number.  Include  your  name,  address

and phone number.

Jabsco is a trademark of Xylem Inc. or one of its subsidiaries. 
© 2014  Xylem, Inc.    81000-384    Rev. G 05/2014 

 

www.flojet.com

U.S.A.
Flojet
17942 Cowan Avenue
Irvine, CA 92614
Phone:  949.608.3900
Fax:      949.608.3887

UNITED KINGDOM
Flojet
Bingley Road, Hoddesdon
Hertfordshire EN11 OBU
Tel: +44 (0) 1992 450145
Fax: +44 (0) 1992 467132

JAPAN
NHK Jabsco Company Ltd.
3-21-10, Shin-Yokohama
Kohoku-Ku, Yokohama, 222
Tel: 045.475.8906
Fax: 045.475.8908

GERMANY
Jabsco GmbH
Oststrasse 28
22840 Norderstedt
Tel: +49-40-53 53 73 -0
Fax: +49-40-53 53 73 -11

ITALY
Jabsco Marine Italia
Via Tommaseo, 6
20059 Vimercate, Milano
Tel:  +39 039 685 2323
Fax: +39 039 666 307

Содержание FLOJET 3526 Series

Страница 1: ...turn faucets off Remember you are filling the water heater and the toilet and shower lines When all valves are shut off pump will stop Should pump fail to stop turn switch off and see the trouble shooting guide CAUTION Pump surface will get hot to the touch if operated for extended periods of time under pressurized conditions 2 25 3 12 4 24 4 75 3 18 9 04 80 mm 65 mm 229 mm 80 mm 108 mm 121 mm DIM...

Страница 2: ...supporting weight of pump STEP 5 Install inlet A and discharge B port connectors Firmly push slide clips C forward to lock port connectors in place STEP 6 Install a Flojet strainer in an accessible location for inspection and cleaning between the tank and pump inlet This strainer or equivalent is required for pump warranty to be valid STEP 1 Use 14 gauge stranded wire to 20 12 gauge to 50 from pow...

Страница 3: ... Air leak at pump intake Accumulation of debris inside pump and plumbing Worn pump bearing excessive noise Punctured pump diaphragm pump leaks Defective motor EXPLODED VIEW The above part numbers are packaged with 2 fittings per bag STRAINERS Pump Series Strainer Number Inlet Outlet Screen 3X26XXX 1740012 1 2 Barb Quad Port 40 Mesh 1740002 1 2 Barb 1 2 Barb 40 Mesh 1740004 1 2 M Qest 1 2 M Qest 40...

Страница 4: ...mon household bleach needed to sanitize the tank 1 A Multiply gallons of tank capacity by 0 13 the result is the ounces of bleach needed to sanitize the tank 1 B Multiply Liters of tank capacity by 1 0 the result is the milliliters of bleach needed to sanitize the tank 2 Mix into solution the proper amount of bleach within a container of water 3 Pour the solution water bleach into the tank and fil...

Отзывы: