Xylem DIQ/S 281, Руководство по эксплуатации

Страница: 28 / 148

Installation DIQ/S 281
ba76226e02
03/2023
28
Connecting the
cables
The SNCIQ and SNCIQ/UG cables are connected to the terminal strip in the
same way as the SACIQ sensor connection cable (see section 3.5.4):
1 Open the module (DIQ, MIQ).
2 Select any SENSORNET connection. At the same time, look out for the
SENSORNET designation.
figure 3-12 Connecting cables to the MIQ module
1 Cable gland
2 Seal
3 Coupling ring
3 Screw the cable gland (pos. 1 in figure 3-12) with the sealing ring (pos.
2 in figure 3-12) into the module housing.
4 Loosen the cap nut (pos. 3 in figure 3-12).
5 Feed the cable through the cable gland into the module housing.
6 Connect the cable ends to the terminal strip. At the same time, look out
for the designations of the terminals (red / shield / green).
SENSORNET 2
SENSORNET 1
SACIQ SNCIQ
SNCIQ/UG
1
3
2
X6 X5 X4
SENSORNET 2
X3 X2 X1
SENSORNET 1
RED RED SHIELD SHIELD GREEN GREEN
ON
OFF
SN
TERMINA
TO
R