6
Installation Flow Chart
The installation of Input Disconnect configurations for Aquavar CPC drives follows the outline
below. The steps must be carried out in the order shown. At the right of each step are refer-
ences to the detailed information needed for the correct installation of the unit.
NOTE! References in the middle column below are to the Aquavar CPC User’s Manual
(IM167). References in the third column below are to this manual.
Refer to the
Additional Reference
Task
Aquavar CPC User’s Manual
in this Manual
“Installation” Section
PREPARE
for
“Preparing for Installation”
• R7/R8: “Lifting the Drive”
installation
on page 7.
• “Drive Identification” on page 8.
• “Suitable Mounting Location”
on page 9.
PREPARE
the
“Prepare the Mounting Location”
• R7/R8: “Prepare the Mounting
Mounting
Location – R7 and R8” on
Location
page 9.
• “Dimensions and Weights
(Supplement to Aquavar CPC
User’s Manual)” on page 27.
REMOVE
the
“Remove Front Cover”
R7/R8: “Remove Side Panel- R7 and
front cover
R8 NEMA 1 and 12 Enclosures” on
page 9.
MOUNT
the drive
“Mount the Drive”
R7/R8: “Mount the Drive” on
page 10.
INSTALL
wiring
“Wiring Overview” and
“Installing the Wiring (Supplement
“Install the Wiring”
to Aquavar CPC User’s Manual)”
starting on page 10.
CHECK
installation
“Check Installation”
—
REINSTALL
the
“Reinstall Cover”
—
cover
APPLY
power
“Apply Power”
—
START-UP “Start-Up”
—
INSTALLATION
