Xycom XVME 500, Руководство пользователя

Страница: 38 / 102

XVME-500/590 Manual
February, 1988
Table 2-12. Input Connector JKI (cont’d)
Flat Cable Single-Ended
Conductor Configuration
Differential
Configuration
39 ANALOG GND ANALOG GND
40 CH. 29* CH. 13 HI*
4 1 CH. 21*
CH. 13 LO*
42 ANALOG GND
ANALOG
GND
43 CH. 22* CH. 14 LO*
44
CH. 30* CH.
14 HI*
45 ANALOG GND
ANALOG
GND
46
CH. 31* CH. 15 HI*
47
CH. 23* CH. 15 LO*
48 ANALOG GND
ANALOG GND
49 POWER GND/PD GND POWER GND/PD GND
50
EXT TRIGGER EXT TRIGGER
* Those channels marked by (*) are only available after an XVME-910 channel
expansion kit is installed.
2.7.2 Pl Connectors
Connectors Pl and P2 are mounted at the rear edge of the board (see Figure 2-1 or
Figure 2-2).
The pin connections for Pl (a 96-pin, 3-row connector) contains the
standard address, data, and control signals necessary for the operation of VMEbus-
defined NEXP modules.
(The signal definitions and pin-outs for the connector are
found in Appendix A of this manual). The Pl connector is designed to mechanically
interface with a VMEbus defined Pl backplane.
2.7.3 P2 Connector (XVME-590
Only)
The P2 connector is a standard VMEbus P2 backplane connector with 96-pins (3
rows).
(The pin-outs for the connector P2 are found in Appendix A of this
manual.) The P2 connector is designed to interface with a VMEbus defined P2
backplane. The P2 connector for the XVME-590 will accept the input analog signals
via the user defined VMEbus pins on rows A and C (see Table 2-13).
2-22