Page 1 of 15
Version 2.1, 9 September 2015
xxter Mobotix intercom configuration
xxter can be used as an intercom system in combination with several Mobotix models. You can use
the T24 / T25 intercom devices or the S14M / S15M camera’s in combination with an audio-‐mount
and e.g. our intercom kit. More information about the separate parts and options can be found in
our intercom kit product sheet.
This manual can be used for several models and options. For some specific devices or options,
specific settings are required. When this is the case, this is clearly stated. In general there are two
configuration options:
a)
Without the use a SIP server, for a Mobotix in combination with only xxter as a client
b)
With a SIP server, for situations where you also want to use other SIP clients, for example a
fixed phone on the wall, near the entrance door.
In addition to these options there are several other options: when using the S14/S15 models, are the
push buttons and door release connected to KNX, or e.g. to a MX-‐OPT-‐IO1 or a MX-‐232-‐IO-‐Box?
This manual will state when a specific setting is needed for a specific situation, or when to skip a part
because another option is used.
All screenshots in this manual are made with a S14 camera with firmware version 4.21.61 installed.
Some screenshots might differ, but most settings should be the same. Please make sure you use
xxter firmware version 1.9.14 or higher.
This manual does not describe how to set up the initial settings of the camera and xxter unit, please
refer to the appropriate manuals to set up the initial IP settings. When using the Quick Installation
Wizard of the Mobotix camera, please select the following options: Switch the microphone and
speaker to on, and select JPEG encoding for the camera.
The configuration and installation will proceed with the following steps:
1)
Configure the audio / video settings
1.1) Configuration for the Mobotix camera
1.2) Configuration for xxter
2)
Configure the push buttons and the alert service
2.1) Configure the alert service
2.2) Configure the push buttons in the Mobotix
3)
Configure the contact to open the door
4)
Connect from the Internet
