6. Basic Operation
POWER ON
Plug power cord into the electrical socket (the LED on the monitor will light
up RED) and press ' ' key on the front panel, then press the POWER
button on the Remote Control to turn on the monitor. The LED on the monitor
will light up GREEN when it is ON.
STANDBY
Press the POWER button on the Remote Control. The monitor will be in held
in standby mode. (the LED on the monitor will light up RED)
NOTE:
1.The monitor set will automatically set to Standby mode if there is no
signal input for 5 minutes when the monitor turns on.
2.The monitor set will automatically set to Standby mode when the preset
time of turning off is reached.
SIGNAL SOURCE SELECTION
1. Press the SOURCE button either on the Remote Control or on the Front
Panel. A menu will be displayed on the screen as shown above.
2. Navigate using the UP/DOWN buttons on Remote Control or CH+/CH-
buttons on the Front Panel to select the signal source from the list.
3. Press the OK button on the Remote Control or MENU button on the Front
Panel to set.
S
O
U
R
C
E
+
-
M
E
N
U
Source
CH+ CH- Vol+ Vol- Menu
Cursor Keys
BNC
AV
S-VIDEO
PC
nu
Po
w
er
