Voltage:
3.6V
Battery Capacity:
1.5Ah Li-Ion
Chuck Size:
6.35mm
No Load Speed:
180/min
Max. Torque:
2.5Nm
Charge Time:
3-5hours
Tool Weight:
0.7kg
SPECIFICATIONS
USING YOUR
SCREWDRIVER
OPERATING THE
SCREWDRIVER
On/Off Trigger
1. Squeeze the on/off trigger to start the screwdriver.
FIG. C
2. To stop the screwdriver, release the on/off trigger.
Note:
This screwdriver does not have variable speed.
Forward Reverse Selector
1. For forward rotation, push the fwd/rev selector
towards the left side of the tool.
FIG. D
2. For reverse rotation, push the fwd/rev selector
towards the right side of the tool.
LED Worklight
1. The LED Worklight will illuminate when the on/off
trigger is pressed.
Note: The LED light can be used without the screwdriver
operating by pressing the forward reverse selector into
the middle position.
Rotating Handle
The rear handle of the screwdriver can be rotated so
that the tool can be operated in 2 different configurations
to assist with your job requirements. The in-line
orientation allows you to drive and remove screws in
hard to reach areas.
1. To operate the screwdriver in the in-line orientation,
press the handle lock button and then rotate the rear
handle.
FIG. E
2. To operate the screwdriver in the angled position,
press the handle lock button and then rotate the rear
handle.
FIG. F
Driving and Removing Screws
1. Depress and release the variable speed trigger to
ensure it is not locked.
2. Check the forward/reverse selector is in the desired
setting.
3. Ensure the workpiece is secured to stop it turning
whilst driving.
4. Hold the tool firmly and then press the variable speed
trigger.
5. Once complete, release the variable speed trigger.
Note: Do not force the tool or apply side pressure to
elongate the hole. Let the tool do all the work.
WARNING!
Ensure the tool is turned off
and disconnected from the power supply
before performing any of the following
operations.
This tool is intended for use in a DIY (Do It Yourself)
context or for hobbyist purposes. It is not built for
continuous daily use in a trade or professional capacity.
Before using the machine, carefully read these
instructions, especially the safety rules to help ensure
that your machine always operates properly.
Before attempting to operate the machine, familiarise
yourself with the controls and make sure you know how
to stop the machine quickly in an emergency.
Save these instructions and the other documents
supplied with this machine for future reference.
Charging Your Battery
1. Plug the charging jack into socket at the bottom of the
tool handle.
FIG. A
2. Connect the charging adaptor into the power supply.
3. The charging light on the front of the tool handle will
illuminate, indicating the battery is charging.
4. The battery will take 3-5 hours to charge.
Fitting Driver Bits
1. Slide the required driver bit into the magnetic hex
chuck.
FIG. B
2. To remove the driver bit, simply pull the bit out of the
magnetic chuck.
4
WARNING!
The power supply for this
charger should be protected by a residual
current device (rated at 30mA or less).
CAUTION:
Do not handle driver bits or
other accessories without gloves as they are
sharp and can become hot after use.
