XTZ 99.25 LCR, Руководство пользователя

Страница: 8 / 11

8
CABLES Try to keep them as short as possible. By its electrical parameters, a long
conductor will have a larger influence on the sound than a short one.
The subwoofer cable should be shielded, to avoid noise.
Make sure that all connections are clean and not oxidized. All connec-
tions should be mechanically stable, both power, signal and loudspeak-
er cables. Signal cables should be separated from other cables.
FINALLY
Please remember that good sound is a matter of taste, so you have to
experiment to obtain it.
We wish you the best of luck!
MOUNTING AND CONNECTING TIPS
MOUNTING ALTERNATIVES Normally the 99.36 FLR is placed standing by a wall. The wall behind
and the wall beside the loudspeaker have influence on both the bass
level and the bass characteristics, so please be patient and try different
distances to the rear and side walls.
CONNECTING USING THE
CORRECT PHASE
Always connect using the correct phase, from the +-pole on the amplifier
to the +-pole on the loudspeaker and corresponding for minus (-).
If you by accident connect the
other way, there is no risk of
damage. However, the sound
will not be correct, especially
in the lower frequencies.
OVERLOAD At high load during extensive time periods, there is always the risk of
overloading the driver and amplifier.
All loudspeakers have a lim-
ited patience for high power,
so be careful not to play ex-
tremely loud and not to in-
crease treble or bass settings
to much.
By increasing the bass or
treble from 0 to max you will
increase the power by about
16 times.
THE INITIAL PLAYING TIME It takes about 50 to 100 hours of initial playing time, for the driver to
sound optimal. During this time, the speaker may be used normally.