1.
Designate a work area that is clean and well-lit. The work area must not allow access by children or pets
to prevent distraction and injury.
WORK AREA SET UP
2.
Route the power cord along a safe route to reach the work area without creating a tripping hazard or
exposing the power cord to possible damage. The power cord must reach the work area with enough extra
length to allow free movement while working.
3.
Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4.
There must not be objects, such as utility lines, nearby that will present a hazard while working.
PRIOR TO OPERATION
1. POWER SOURCE:
Ensure that the power source to be utilized conforms to the power requirements
specified on the product nameplate.
2. GROUNDING:
This tool should be grounded while in use to protect the operator from electric shock.
This tool is equipped with a three-conductor cord and grounding plug to fit the proper grounding receptacle.
The green (or green and yellow) conductor in the cord is the grounding wire. Never connect the green (or
green and yellow) wire to a live terminal.
3. POWER SWITCH:
Ensure that the power switch is in the OFF position. If the plug is connected to a
power receptacle while the power switch is the ON position. The power tool will start operating immediately,
possible causing serious injury.
4. EXTENSION CORD:
Use an extension cord of sufficient thickness and rated capacity. The extension
cord should be kept as short as possible.
5
OPERATION
INSTALL / REMOVE ACCESSORIES
By installing and removing accessories, please make sure the tool is OFF and the power cord is removed
from the power source.
1.
Pull out the bolt (1) and swivel it to make the flange towards the direction of
the motor housing. Insert the accessory into the tool holder through the dust
shield, while twisting and pushing inward until it locks automatically into place.
2. Auxiliary Handle:
The tool must be supported with the auxiliary handle (1)
which can be swivelled 360 °. To reposition and/or swivel the handle, loosen
the hand grip (2) then move the handle to the desired position along the barrel
(3) and securely re-tighten the hand grip.
3. Switch Operation:
If you want to operate the tool, you only need to press
switch (1). If you want to operate the tool non-stop, you can switch and press
the locking button (2). If you want to stop the tool, press the switch again and
release.