9
F. Remote Control Sensor:
1.
Remote control sensor receives infrared (IR) signal from the remote control. The maximum distance for IR data transmission is 10
feet and requires direct line of sight. The transmission distance may vary depending on temperature and remote control battery
condition.
2. Light settings are independent from other settings (including power-off delay) and lights have to be manually turned on or off.
3.
The system saves user configurations, settings such as light, timer and blower (motor) speed will remain the same the next time it is
turned on.
2. FOR PX01, PX03,PX04, PX04-B, & D02 Model: TYPE 2: BUTTON TOUCH CONTROL PANEL
Importance Notice:
1. 2 ½ HOUR AUTOMATIC SHUT OFF: this range hood will be shut off for every approx. 2 ½ hour. You can re-start
operation as usual after it was shut off.
2.
30 HOUR REMINDER: after 30 hours of use, the timer (8) will be flashing. To clear it, please refer to “G-To Clear
Cleaning Reminder” on page 7.
A. ACTIVATING BLOWER FUNCTION:
Option 1: Touch and hold down (+) for 1-2 seconds.
Option 2: Touch and hold down power sign (1) for 1-2 seconds. (The blower will be running at the same speed as last used).
Note
: The system saves user configurations, settings such as timer and blower (motor) speed will remain the same the next time it is turned on.
B. ADJUSTING BLOWER SPEED:
Touch and hold down (+) for increase.
Touch and hold down (-) for decrease.
C. TURNING OFF THE BLOWER:
Touch and hold down power sign (1) for 1-2 seconds.
D. TO TURN THE LIGHT ON/OFF:
Touch Light button (6) once to turn on the lights, and once again to turn off the lights.
E. ADJUSTING THE TIMER FUNCTION:
While the blower (motor) is not running, touch and hold Decrease Value button (2) 1-2 seconds or until it’s flashing to enter timer mode.
Adjust to desired period of delay off timer by touching Increase Value or Decrease Value
button (minimum 1 minute to maximum 15 minutes).
This setting will be saved immediately.
F. ACTIVATING THE TIMER FUNCTION:
While the blower (motor) is running, touch and hold “Power” button (1) for 1-2 seconds til you see “BLUE L” to activate delay off timer.
Power-Off Delay
Timer Indicator
(10) will light up and
Power-Off Delay Digital Timer
(9) will begin to countdown. When it reaches zero, the blower (motor) will shut down.
G. TO CLEAR CLEANING REMINDER:
When blower (motor) starts to rotate, cumulative running time will be shown in
Power-On Elapsed Digital Timer (8)
. This timer icon flashes when 30 hours
is up and reminds user to clean the baffle filters.
After cleaning the filters and when the motor is not in use, touch and hold (+)
Increase Value
button (7) over 3 seconds to reset the timer. Please note
that turning off the system will not reset the
Power-On Elapsed Digital Timer (8)
.
