Xtreme Power 90151, Инструкция по эксплуатации и правила безопасности

Страница: 2 / 20

IMPORTANT SAFETY INFORMATION
GENERAL SAFETY WARNINGS
Read all safety warnings and instructions. Failure to follow the warnings and instructions may result
in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
SAFETY
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be supplied by the operator. Read
carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to
follow the safety rules and other basic safety precautions may result in serious personal injury.
Disconnect all AC power during installation.
DO NOT permit children to use this product.
A green colored screw is located inside the wiring compartment, against the back panel. To reduce the
risk of electric shock, this terminal must be connected to the grounding means provided in the electric
supply service panel with a continuous copper wire equivalent in size to the circuit conductors supplying
the equipment.
One bonding lug for US models (two for Canadian models) is provided on the external surface. To reduce
the risk of electric shock, connect the local common bonding grid in the area of the swimming pool, spa,
or hot tub to these terminals with an insulated or bare copper conductor not smaller than 8 AWG US/6
AWG Canada.
OPERATION
1
All field-installed metal components such as rails, ladders, drains, or other similar hardware located
within 10 feet (3 meters) of the pool, spa or hot tub shall be bonded to the equipment grounding bus with
copper conductors not smaller than 8 AWG US/ 6 AWG Canada.
Operation
The SPS is an automatic chlorine generation system for pool & spa sanitation. The operation requires a
low concentration of salt (sodium chloride) in the pool water at levels low enough that it normally cannot be
tasted. SPS automatically sanitizes your pool by converting the salt into free chlorine, which kills bacteria
and algae in the pool through a process called electrolysis.
SPS is designed to handle the purification needs of the average residential swimming pool up to 40,000
gallons (150,000 liters). The actual amount of chlorination required to properly sanitize a pool varies
depending upon bather load, rainfall, air temperature, water temperature, pool’s exposure to sunlight,
pool’s surface, and cleanliness.
NOTE: It is not recommended using the SPS to generate Bromine. If your pool has natural stone as
coping or decking, please check with a stone installation specialist for the maintenance of the stone before
installing the SPS.