INSTALLATION
6
5. Connect the sand tank to the pump with hose and hose adapters.
INSTALLATION NOTES:
Make sure the filter has worked under work pressure and using a pressure control valve when the
system is using a booster pump.
If the pump position is higher than the water level, it requires installing an isolation valve. It can stop
the water return back when doing the general inspection.
If the pump position is higher than the water level, it requires installation of the back water control
valve.
Reduce the connection adapters and hose connection, bending as little as possible. Decreasing the
water flow scrub can reach the maximum effectiveness
Ensure solvents are not excessively applied to the fitting as this can run onto the O-ring and create
sealing issues.
Do not over tighten fittings or adapters.
HOW TO USE:
1. Inspect all connections have been made and are secure.
2. Depress the top mount valve handle and rotate to
BACKWASH
position.
3. Prime and start pump according to the pump instructions.
NOTE
All suction and discharge valves must be opened when starting the system. Failure to do so can
cause severe personal injury. Make sure the filter vessel are full. Fill the water before start-up the
pump. Failure to do so can cause damage to the pump.
4. Once water flows steadily out of the waste line, run the pump for at least 2 minutes. The initial back-
washing of the filter is recommended to remove any impurities of fine sand.
5. Turn the pump off and set the valve to
RINSE
position. Start the pump and operate until water in the
sight window is clear. Turn the pump off and set the valve to the
FILTER
position and restart the pump.
Your filter is now operating in the normal filter mode, filtering particles from the pool water.
