Xtreme Power 75132, Инструкция по эксплуатации и правила безопасности

Страница: 5 / 9

4
IMPORTANT SAFETY INFORMATION / INSTALLATION
Always turn pump off before changing valve positions. Changing valve positions while the pump
is running can damage the control valve, which may cause serious injury or property damage.
Allowing water to freeze in the system will damage the system and cause potential water damage/
flooding and potential property damage.
SAND FILTRATION WORKING PRINCIPLE
Incoming water from the piping system is automatically directed by the multi-port valve to the top of the
filter bed. As the water is pumped through the filter sand, dirt and debris are trapped by the filter bed, and
filtered out. The filter water is returned from the bottom of the filter tank., through the multi-port and back
through the piping system .
PREPARATION BEFORE INSTALLATION
1.
Position the filter as close to the swimming pool / spa as possible.
2. The filter should be placed on a level, concrete slab, firm ground or equivalent.
3. Position the filter near piping so that it is convenient for operating and servicing.
4.
Ensure that the compliance label is facing front to allow easy identification.
INSTALLATION
1. Pump needs screw and cover to install on the filter drain.
2. Press and turn the sand tank to mount it to the sand filter support with correct direction, drain plug on
the outside (see below)