Xtreme Power 75061, Инструкция по эксплуатации и правила безопасности

Страница: 8 / 10

TROUBLESHOOTING
If the cleaner fails to pick up fine or heavy debris: Clean the filter bags. A filter cleaning
solution can be used to remove excessive dirt and/or sand.
If the cleaner starts working momentarily but then stops working: Impeller may be clogged
with debris. Check and clean if necessary.
There are two inlets located at the bottom of the cleaner and near the brushes. Inlets
located next to brushes help collect debris.
If the cleaner is being used in an area with a lot of sands, the cleaner may need to be
rinsed off on the main body and at the cover and outlet to allow free operation.
During normal operation, the cleaner will rise to allow the unit to clear any obstructions.
If the cleaner has poor coverage on one cycle, or only covers one area:
Check the filter and clean if necessary and make sure the unit is not getting caught in
drains. Try starting the cleaner in a different location.
ALWAYS put the machine in the water before connecting it to the electrical outlet.
If debris falls from the cleaner while removing from the pool, it may be caused by filter
overload. Increase the frequency of filter cleaning. Assure that there is no large debris
blocking the two inlets.
If drain flaps are out of place or stuck by sand/leaves in the open position, the flaps can
be snapped back into place, after cleaning the area.
Avoid dropping or throwing the machine into the pool. Place the cleaner away from the
pool wall and set it into the pool carefully.
If the location cord gets twisted which can be caused by the cleaner working for too
long, it can be straightened by laying the location cord in the sun. Heat from the sun will
help reduce twisting.
If a lot of debris is visible though the outlet, remove cleaner quickly from the water to
reduce the chance of debris escaping the filter bag and re-entering the pool.
Thoroughly rinse the entire unit after each use.
Clean the filter bags thoroughly after each use. A clogged filter can decrease efficiency
dramatically.
Avoid allowing the unit to “cool down” in the water.
NEVER use an extension cord with this machine. This can create a safety hazard and/or
damage the cleaner. Be sure the machine is plugged into a grounded outlet.
If the supply cord has been damaged, it must be repaired by a qualified technician
before operating the machine again.
Inspect the filter bags frequently, replace when necessary.
While the cleaner has been made to operate as safely as possible, we suggest you
exercise reasonable care in the handling of the vacuum and inspect the electrical cord
frequently for damage or wear. After use, remove the unit and rinse with fresh water and
remove any twists that may be present in the cord.
7