SAFETY INFORMATION
OPERATION
1
2
SPA PUMP POSITION
If the spa bath pump is supplied separately to the spa bath, position the pump as close as possible to the spa.
This will ensure optimum spa jet performance.
The spa pump must be protected from exposure to weather .It is important to ensure that there is adequate
ventilation provided for the spa pump (minimum area 104 sq cm). Without adequate ventilation the pump motor
will over-heat causing nuisance motor stops and starts. Failure to comply with these instructions may cause
pump damage.
SAVE THESE WARNINGS.
PLUMBING INSTALLATION
The spa bath pumps are supplied complete with integrated barrel unuons to allow easy installation of PVC
pipework. The spa bath pump must be mounted below the normal operating spa bath level but above the spa
bath to ensure correct pump priming and pump/pipe drainage (see Fig.1) All water must drain back into the sap
when emptied .This is in accordance with local Health Department Regulations. Ensure pipes rise evenly from
the spa bath to the spa bath pump to avoid airlocks (otherwise the spa pump will not prime, refer Fig.1).All pipe
connections must be watertight. Never allow spa pump to run without water as this may result in damage to the
pump sea.
Special Note:
To avoid water damage to property from leaking connections or normal wear, the pump must be installed on a
well drained site or a properly constructed drain tray.
ELECTRICAL CONNECTION
Plug the spa pump power cord into a dedicated power socket and switch the power on. All spa bath pumps must
be installed in accordance with relevant electrical standards. Terminal box cover should be securely in place
before connecting the pump to electricity to prevent electric shock or injury. Motor is fitted with auto-rest thermal
switch and may restart without warning. our spa pumps are suitable for connection to 110-120/220-240volt 60Hz
power outlets. Some models will require a 12Amp outlet .Check motor I.D. label for details. All pumps must have
a dedicated power supply.
