Xtreme Power 65150, Руководство пользователя

Страница: 2 / 5

SPECIFICATIONS
Tank capacity 30GAL
W/One Couplers & One Gauges
! WARNING:
Displacement 900
L
@900rpm
Always wear approved protective eyewear. when using tools.
Working Pressure ：9 BAR
Read and observe all safety rules included in your tool owner's manual.
Oil Lubrication For Long Life
Belt Drive Compressor Pump
Engine power
SAFETY PRECAUTIONS (Read all instructions before using this product)
Please familiarize yourself with the following information to prevent damage to your compressor and injury to the operator, property damage, or death.
Tank safety valve
-This valve is factory installed to prevent the air receiver form damage should a malfunction occur in the compressor pump.
-It is factory set at a specific limit for your particular model and adjustment and should never be tampered with adjustment by user will automatically void
warranty.
Compressor pump
-Air compressors get hot while in operation. Never touch the engine, discharge tubing, or compressor pump while in operation.
-The compressor operates automatically while starting.
Compressed air caution
-Compressors air from the unit may
contain carbon monoxide. Air produced is not suitable for breathing purposes.
-Always use a respirator when spraying paint or chemicals.
-Always wear safety glasses or goggles when spraying air.
Air receiver
-Over pressurizing the air receiver
could cause an explosion or rupture. To protect from over pressurizing a factory preset safety value is included. Do not
remove, make adjustments or substitutions for this valve.
-Occasionally pull the ring on the valve to make sure that the valve operates freely. If the valve does not operate freely, it must be replaced. Never weld to,
drill into, or change the air receiver in any way.
-If any of the above conditions are changed or tampered with this will result in voiding of the manufacturer's warranty. Be advised that any replacement parts
should be purchased with the same specification as the original equipment. Please contact your authorized dealer for replacement parts or specifications.
Others
-Do not smoke while operating the
air compressor. To avoid the ignition of a fire or explosion, never spray where sparks or flame is present.
-Keep the compressor away from children and those who are unfamiliar with the unit operation.
INSTALLATION AND OPERATING INSTRUCTIONS
General information
Depending on the C.F.M. draw of the
tools being operated, your new air compressor can be used for operating paint sprayers, air tools, grease guns,
airbrushes, caulking guns, sandblasters, inflating tires and plastic toys, etc. An air pressure regulator is usually necessary for most of these applications.
General description of operation
To compress air, the pistons move up down in the cylinder, On the down stroke, air is drawn in though the valve inlet. The discharge valve remains closed,
On the upstroke of the piston, air is compressed. The inlet valve closes and compressed air is forced out through the discharge valve, through the check
valve and into air receiver. Working air is not available until the compressor has raised the air receiver pressure above that required at the air service
connection. The air inlet filter openings must be kept clear of obstructions, which could reduce air delivery of the compressor.
Installation and location
Locate the compressor in a clean, dry
and well-ventilated area, The compressor should be located 12 to 18 inches from a wall or any other
obstruction that would interfere with the air flow through the fan blade belt wheel. Place the compressor on a firm level surface . The
compressor is designed with heat dissipation fins that allow for proper cooling. Keep the fins and other parts that collect dust or dirt clean.
A clean compressor runs cooler and provides longer service, Do not place rags, containers, or other material on top of the compressor.