Xtreme Power 5850GPH, Инструкция по эксплуатации и правила безопасности

Страница: 8 / 13

7
START-UP AND OPERATION
PUMP DISCHARGE POSITION
Step 1: Remove ALL plumbing attached to pump.
Remove pump from base (if applicable).
Step 2: Remove strainer housing.
 Disengage and lift off strainer cover.
 Remove strainer basket.
 Lift up on strainer ‘C’ clip and remove.

Slide strainer housing forward and remove.
Step 3: Press positioning button located on pump housing and rotate discharge port to desired position.
Step 4: Assemble the pump by following the above directions in the reverse manner.
PRIOR TO START-UP
Fill strainer housing with water to suction pipe level. NEVER operate the pump without water. Water acts
as a coolant and lubricant for the mechanical shaft seal.
NEVER
run pump dry. Running pump dry may damage seals, causing leakage and flooding. Fill strainer
housing with water before starting motor.
DO NOT add chemicals to pool/spa system directly in front of pump suction. Adding undiluted chemicals
may damage pump and voids warranty.
Before removing strainer cover:
1. STOP PUMP before proceeding.
2. CLOSE VALVES in suction and outlet pipes.
3. RELEASE ALL PRESSURE from pump and piping system.
If pump is being pressure tested, be sure pressure has been released before removing strainer cover.
PRIMING THE PUMP
Clean and lubricate strainer cover O-ring with “Jack’s 327” each time it is removed.
Clean and inspect O-ring; re-install on strainer cover.
Replace strainer cover on strainer housing; turn clockwise to tighten cover.
NOTE: Tighten strainer
cover by hand only (no wrenches) ¼ turn.
Open all valves before starting system.
Release all air from filter and piping system.
With suction and outlet valves open and water source higher than the pump and flowing, pump will
prime itself.
If pump does NOT prime within ten minutes, stop motor and determine cause. Be sure all suction and
discharge valves are open when pump is running. See Troubleshooting Guide.
EXPLOSION HAZARD:
Purging the system with compressed air can cause components to explode,
with risk of severe injury or death to anyone nearby. Use only a low pressure (below 5 PSI), high volume
blower when air purging the pump, filter, or piping.
Allowing the pump to freeze will void the warranty.
DO NOT use anti-freeze solutions (except propylene glycol) in your pool/spa system. Propylene glycol
is non-toxic and will not damage plastic system components; other anti-freezes are highly toxic and may
damage plastic components in the system. Gravity drain system as far as possible.