Xtreme Power 196CC, Инструкция по эксплуатации и правила безопасности

Страница: 17 / 28

17
GB
Add Oil To Engine
1. Make sure the log splitter is on a flat, level
surface.
3. Using a funnel, add oil up to the FULL mark
on the dipstick. (See engine manual for oil
capacity, oil recommendation, and location
of fill cap.)
1. The engine must be off and allowed to cool
at least two minutes before adding fuel.
2. Remove the fuel filler cap and fill the tank.
(See engine manual for fuel capacity, fuel
recommendation, and location of fuel cap.)
3. Reinstall the fuel cap and tighten. Always
clean up spilled fuel.
Add Gasoline To Engine
2. Remove the oil fill
cap/dipstick to add
oil.
CLOSED OPEN
Add Hydraulic Oil To Oil Tank
1. Make sure the log splitter is on a flat, level
surface.
2. Remove the oil dipstick from the oil tank.
Operation
Many accidents occur when more
than one person operates the log
splitter.
If a helper is assisting in loading
logs to be split, never operate the
controls until the helper is clear of
the area.
IMPORTANT: DO NOT OVERFILL!
This equipment and/or its engine
may include evaporative emissions
c o n t r o l s y s t e m c o m p o n e n t s ,
required to meet EPA and/or CARB
regulations, that will only function
properly when the fuel tank has been
filled to the recommended level.
Overfilling may cause permanent
damage to evaporative emissions
control system components. Filling
to the recommended level ensures
a vapor gap required to allow for
fuel expansion. Pay close attention
while filling the fuel tank to ensure
that the recommended fuel level
inside the tank is not exceeded. Use
a portable gasoline container with an
appropriately sized dispensing spout
when filling the tank. Do not use a
funnel or other device that obstructs
the view of the tank filling process.
A l w a y s c h e c k o i l l e v e l b e f o r e
starting the engine and keep level
full.
The hydraulic reservoir should be
filled with hydraulic fluid before
starting or operation
Gasoline is highly flammable and
explosive. You can be burned or
seriously injured when handling fuel.
Use extreme care when handling
gasoline.
Never remove the hydraulic oil
dipstick when the engine is running
or hot. Hot oil can escape causing
severe burns. Allow the log splitter
to cool completely before removing
the hydraulic oil dipstick.
Fill the fuel tank outdoors, never
indoors. Gasoline vapors can ignite
if they collect inside an enclosure.
Explosion can result.
DO NOT OVERFILL. Check engine
oil level daily and add as needed.
3. The recommended hydraulic oil type:
10W AW32
ASLE H-150
ISO 32
OPERATION OPERATION