Xtreme Power Conversion XPRT?1000, Руководство пользователя и инструкция по установке

Страница: 27 / 49

XPRT ‐ 1000, XPRT ‐ 1500, XPRT ‐ 2000, XPRT ‐ 3000 USER’S MANUALUNINTERRUPTIBLE POWER SUPPLY (UPS)
[27]
TROUBLESHOOTING
Note: The Audible Alarm can be silenced by pressing any one of the three buttons on the front of the UPS, except
when a low ‐ battery condition exists. The audible alarm can also be permanently disabled in the configuration
section.
Displayed on
LCD
Audible
Alarm
Alarm Description What You Should Do
Output
Overload
Two Beeps
per second
The UPS is overloaded (in Line
Mode). Your equipment needs
more power than the UPS can
provide. The UPS operates in
bypass.
Shut off the least important equipment
connected to the UPS. If this solves the
overload problem, the UPS will switch
from bypass back to normal operation.
Battery Test No Beeps The UPS is doing a battery test.
No action needed. The UPS will return
to normal operation when it
successfully completes the battery
test.
Over ‐ Charge
Constant
beep
Batteries are overcharged.
Turn off protected loads. Turn off UPS
and call your local dealer
Low Battery
2 beeps
every
5seconds
The unit is operating on Battery
Power and will shut down soon due
to very low battery voltage.
The ON Battery LED will also flash
The unit will restart Automatically
when acceptable power returns.
On ‐ Battery
Once every 5
seconds
The unit is operating on Battery
Power.
Save your data and perform a
controlled shutdown.
Charger Failure
Constant
beep
Charger has failed. Phone the local dealer
Over ‐
Temperature
Constant
beep
High ambient Temperature.
If the internal temperature is higher
than 55C, the UPS will shutdown.
Allow the UPS to cool. Make sure the
unit’s fans and vent holes are not
blocked. Make sure the ambient
surrounding temperature is not above
40 degree C. If these actions do not
solve the problem, call your service
representative.
Output Short
Constant
beep
Output short circuit Call the Local dealer
High output
Voltage
Constant
beep
High output voltage Call the Local dealer
Low Output
Voltage
Constant
beep
Low output voltage Call the Local dealer
Bus Fault
2 Beeps per
second
High internal DC bus Voltage.
Turn off protected loads. Turn off UPS
and call your local dealer
Site wiring
Fault
1 Beep per
second
Voltage detected Between Neutral
and Ground
UPS mains connector polarity Wrong.
Rotate the connector (Schuko). UPS
installed to mains supply without
ground.
Line abnormal
1 Beep per
second
Wrong AC Line backed up during
auto restart