ASSEMBLY AND OPERATING INSTRUCTIONS
CAUTION:
Read and follow all instructions before operating fan.
Do not use fan if any part is damaged or missing.
WARNING:
To reduce the risk of fire or electrical shock, do not use this fan with any solid state speed control device.
This appliance has a 3-prong plug. To reduce the risk of electrical shock, this plug is intended to fit in an outlet only
one way. If this does not fit the outlet, contact a qualified electrician. Do not attempt to bypass this procedure.
RULES FOR SAFE OPERATION:
z
Never insert fingers or any other objects through the grill guard when fan is in operation.
z
Unplug the fan before moving from one location to another.
z
Unplug the fan before removing guards for cleaning.
z
Do not use with an extension cord.
z
Do not place fan or any parts near an open flame, cooking appliance, or any other heat source.
z
Do not use fan in windows.
z
Only plug fan into GFCI protected receptacles.
ASSEMBLY INSTRUCTIONS: Wall or Ceiling Mounting – Permanent Mounting Only
1.
Locate solid wall stud or ceiling beam. Mark the center of the beam. If you do not
have a solid structural framing member at that location then you must provide an
adequate alternative for mounting the fan.
2.
Drill pilot hole for 3/8” lag bolt.
3.
Secure with Proper Hardware, (not included).
NOTE: Only plug fan into a GFCI outlet.
OPERATING INSTRUCTIONS
1.
To Direct Vertical Airflow:
Tilt the fan head up or down to the desired angle
and lock in place using securing assist knobs on side of frame.
2.
To direct Horizontal Airflow:
Rotate the fan head right or left to attain the
desired directional air flow and Not provided .
3.
Speed Control:
Pull Switch to Low, Medium or High speeds for desired air velocity. It is normal for the motor to
feel warm to touch during continuous operation. This fan features a thermostat that will automatically shut off
should it overheat for any reason. If this happens, immediately unplug the fan from the outlet.
How To Adjust Tilt
1. Use knob screw to loose by turning counter-clockwise.
2. Adjust fan head to tilt you want.
3. Tightened the knob screw by turning clockwise.
Knob
Screw
Locking
Screw
Mounting
Lag
Bolt
