XTONEBOX Silver 6011, Руководство пользователя, Страница: 8 / 12

8
INPUTS . There are three sources that need to be connected physically to the Silver
6011: AUX1, AUX2 and PHONO. These are stereo, so there are two inputs (R & L) per
source.
CHASSIS GROUND . If a hum is heard when playing vinyl records, this is an indication
that the record player or its connections are inadequately grounded or shielded.
Connect a separate ground wire from the turntable to the CHASSIS GROUND (as
indicated in PREPARATION FOR USE).
Each time you POWER ON this unit please check the following points:
 Audio valves are properly installed.
 Each speaker output is connected to its corresponding speaker, using a proper
cable. Make sure that the passive speakers you are using have a proper rated
impedance.
 The IEC Cable are properly plugged. IEC with ground terminal is required for
safe operation and reduction of background noise.
To turn on this unit, first press the POWER button (LEDs should light up, if they
don't, please verify that the IEC Cable are properly plugged) and wait 30 seconds for
the valves to warm up (you should hear a little
"click" after 30 seconds, this means
that the internal audio signal has been enabled). At this point your Silver 6011 will be
ready to play your favorite music. Enjoy!
To pair your Silver 6011 with a Bluetooth device, first you have to power on the
amplifier so it is discoverable (is not necessary to select BLUETOOTH (BT) source on
the amplifier for pairing). Then, set your Bluetooth device to discoverable. On the
Bluetooth device list shown on your device, select XTONEBOX Silver-6011 .
When connected, remember to turn up the volume on your bluetooth device
to maximum or near maximum to have adequate volume with the rest of the inputs.
Now you are ready to listen your music wirelessly and with the best sound
quality. To start just select BLUETOOTH (BT) SOURCE .